After ignition, the gas-fired boiler needs to observe the temperature of the furnace smoke and the temperature of the main steam, and the rising pressure of the main steam. After the boiler ignition, the smoke temperature will increase obviously slowly or if the smoke temperature does not rise, we should immediately check the ignition of the oil gun on the spot.

Biomass Fuel boiler plants - References

Biomass fuel boiler for Power Station

When the heating area customers 10t gas heating boiler heating boilers in the choice of gas, usually attention to the problem of heating area, always other conditions, the greater the area of ​​the heating boiler, the customer's natural tendency will be relatively larger. The following small series to the heating area 10t gas heating boiler (hot water boiler) as an example for everyone to do a simple exposition. According to the current state of the ideal heating boiler 1t square area of ​​Zhengzhou Gas boiler in terms of 10,000 square meters, 10t gas heating boilers can provide 100,000 square meters of heating, of course, this is only an ideal state, specific to the actual situation and set. Of course, this is only tested out different boiler manufacturers for different strength of internal data, basically affecting boiler heating boiler area itself, we have to consider the thermal efficiency of the boiler, if the boiler process is relatively good, the use of boiler technology is relatively good, then the thermal efficiency of the boiler will naturally be relatively high, it will directly affect the heating area gas heating boiler. Currently the use of fast Zhengzhou party rigorous process, a more condensed excellent tooling equipment as well as independent research and development, premix technology to create the industry's relatively good gas heating boilers, boiler thermal efficiency can be basically maintained at between 98% -104%, and even higher, so that under all conditions appropriate opposite case, a large area for district heating. In short, the problem with regard to heating area 10t gas heating boiler, measured in terms of the different users of different standards, can be subjected to a simple comparison, choose your favorite, heating larger, transportation of 10t gas heating boiler safe and stable.

Xuchang City in the recently released "2018 campaign of air pollution control plan", especially for the governance of the city's boiler was planned.

Xuchang coal-fired boiler governance objectives:

In Xuchang complete basic steam 10 t / h coal-fired boiler Chaigai, and gradually expand the boiler removal and clean energy transformation of coal-fired range, before the end of 2020, out of a planned urban area 35 steam tons / hour and coal-fired boiler.

Coal-fired boiler subsidy:

(1) the completion of the coal-fired boiler Chaigai before the end of October 2018, giving not less than 60,000 yuan / tons of steam financial awards complement;

(2) the completion of the coal-fired boiler Chaigai before the end of October 2019, giving not less than 40,000 yuan / tons of steam financial awards complement;

(3) complete Chaigai coal-fired boilers for the end of October 2020, the prize money will not give up.

Xuchang boiler out of the way:

Removal, central heating alternative, coal gas, coal to electricity, use geothermal, wind, solar, biomass with a bag filter, to burn not including clean coal, coal-water slurry, anthracite, charcoal blue, green coke, crude oil, coal-fired boiler removal must be removed chimney or flue physical cutting, it does not have the complex production conditions. Do not use has been shut down, eliminated waste coal-fired boilers to cash rewards and subsidies. In the process of new coal-fired boilers to switch to natural gas to be synchronized to achieve low nitrogen transformation.