The reason the gas boiler burner increased noise analysis when making use of the gas boiler and found this small fire normal, but this time turn the fire, extinguished or flashing instability. First speaking, that is because of this fire damper of the air volume setting is too large; i.e. after an oil fire because the micro-switch valve (damper outermost that group) inappropriate setting (set lower than the fire damper of the air flow larger) burner gas noise increases, mostly because the oil shut-off valve which is closed or lack of oil into the oil filter clogging; or, this is because of low temperature into the oil, the viscosity is too high or the pump into the oil temperature is too high; oil pump failure; fan motor bearing damage; there is because the fan impeller dirty equipment resulting in large noise. The above-described failure when using gas boiler, but also because the viscosity is too high oleaginous easy to be atomized (heavy oil); cyclones and because improper disc and the nozzle pitch; Note that because the fire is worn or dirty nipple; also because this preparatory tank the heating temperature is too high, causing the oil pump oil feed steam does not conform; or because the fuel inside the boiler resulting aqueous oil. When the above-described fault gas boiler used to perform this process, the test should be done gradually decreases; after heating temperature should be; adjusting the distance (between 0 ~ 10mm); clean or replace; is set to about 50 deg.] C to about; or drain oil change.

Burns Hospital Affiliated Hospital of Shanxi Linfen Linfen Steel is attending a hospital burns burns and other diseases. Hot water boiler is essential hospital equipment heat, hot water output can provide disinfection of medical instruments and ward heating demand. With constantly improving our environmental policy, boiler correspondingly introduced more sophisticated Use. Linfen hospital burns to respond positively to the national environmental policy, decided to introduce an environmentally friendly low nitrogen gas hot water boiler. Taking into account the special circumstances of the hospital, the boiler should also have the use of safe, clean overall characteristics. Based on the above considerations, finalize the Linfen hospital with burns boiler party cooperation fast, fast is provided by one side of a gas condensing pressure hot water boiler (CWNS2.1-95 / 70-Y.Q).

The use of electric condensing 1500kg fired steam boilers What are the requirements? General Electric steam boiler is to be converted into an energy form of heat, through the conversion of the boiler can be turned into heat energy of steam or hot water, which requires the use of gas when you have it steam boiler, steam boiler in the first before water is necessary to check each valve, steam pipe, pressure variations, water tables, etc. also note the drain valve is not also intact. after the steam inside the boiler should be kept clean to be used, to which water is after softening the outer glass tube in the water table to be equipped with rugged protective cover, but also to keep it clean after each use it is necessary to scrub, as well as to see the water level of the water table there rise or fall, if it stops phenomenon, we must immediately investigate the cause. after the adjustment is not just above the steam boiler safety valve.

The 1 ton wns series oil and gas boiler adopts a horizontal three-return structure, and the boiler produces fast steam and high thermal efficiency. The boiler adopts a large-area combustion chamber. The combustion chamber is surrounded by a jacketed water jacket. A dense fire tube is arranged on the upper part of the combustion chamber, and an advanced combustion device is arranged. The fuel is fully burned in the combustion chamber, and the high-temperature flue gas enters the dense fire tube to continue to radiate heat. Then gathered in the smoke chamber for further heat release.