Natural gas industrial boilers produce condensate water hazards natural gas industrial boilers produce condensate water hazards natural gas industrial boilers produce condensate water hazards 1, the corrosion of condensate water boiler heating surface major harm to the natural gas industrial boilers is the corrosive effect on the heating surface of the boiler. Condensate corrosion WNS rear of the boiler heating surface of the bottom of the tube focus, mainly iron oxide corrosion products. Condensate corrosion can cause intense side wall thinning, strength weakened. (1) condensation with the flue gas evolution corrosion, some CO2 is dissolved in the condensed water, CO2 generated in case of weak electrolyte H2O H2CO3, ionized hydrogen ions, so that a weak acid condensate, and another part of the nitrogen oxides and containing a very small amount of sulfur dioxide dissolved in the condensate, enhances the acidity of the condensate, the pH of the condensed water as in table 1 were lower than the position of the drum 4.3. iron hydrogen evolution corrosion can occur in the acidic solution, and the strong acid, the reaction The faster rate. (2) Since the oxygen etching gas during combustion boiler need to ensure a certain air ratio, combustion flue gas contains oxygen. When the steam condenses, some oxygen will be dissolved in the condensed water, causing corrosion of the metal heating surface of the oxygen. 2, when the cross-sectional area to reduce the flue gas flow type gas boiler industrial boilers operate at low load, the heated surface of the flue gas, the condensed water gathered in the smoke tube, the resulting corrosion products accumulate in the bottom of the tube, even clogging of the pipe part, thus reducing the flow area of ​​the flue gas, the flue gas resistance increases, and increase in power consumption of the blower. 3, the furnace temperature is lowered, damage to the burner within the examination of natural gas in industrial boilers, often find a certain amount of condensed water. We found condensate discharge tube boiler such severe congestion, resulting in condensed water in the lower furnace does not discharge, and refluxed for aggregation. When the boiler is started, the heat accumulated in the furnace absorbs the condensed water and evaporated fuel combustion, thereby reducing the furnace temperature. If the furnace condensate accumulated too much, and even dipped into the burner, causing damage to the burner. Suddenly turn off the boiler, the boiler does not start, because the burner too much condensation water immersion, affecting the safe operation of the boiler. 4. Effect of boiler condensate generated on the heat sealing material penetrates into the sealing material of the boiler insulation, the point of the arrow indicated gas tank gas boiler WNS industrial boilers. Sealing condensed water immersion insulation material for a long time, the insulation effect will be weakened or even physical damage, increased heat loss. Meanwhile, the condensed water will make the sealing material deformation aging, sealing capability weakened, leading to a certain amount of flue gas emissions, which not only be dangerous, can also cause a certain amount of heat loss.

The hotel washing plant with a horizontal type lpg steam boiler Why superheated steam results were better? Under pressure steam boiler, water is heated to be softened, the water temperature is gradually increased, and finally reached the boiling point, is called saturated steam temperature is known as the saturation temperature. Saturation temperature and pressure of the steam boiler is related with the rising pressure, saturated steam temperature is relatively increased, and the steam temperature and pressure is directly proportional. Superheated steam boiler is a steam boiler in the case of constant pressure, saturated steam reheating temperature of the steam will be increased accordingly, referred to as superheated steam boiler. Than the saturated steam superheated steam washing plant is good for effect, because of the water content in the saturated steam superheated steam is relatively higher than in the water content, while washing plant dryer and ironing machine is required temperature , the higher the better quality steam will save some fuel.

In early November, the annual "Technology Innovation Award" announced by the Chinese Ministry of Science and Technology Venture Association. Fast Boiler Co., Ltd. With strong R & D strength and strong R & D hardware infrastructure was awarded The "Technology Innovation Award (business)," the honorary title.

Some manufacturers generally designated brochure design heat boiler efficiency of 90%, but the actual thermal efficiency can only reach 70% -85%; which exhaust gas temperatures are in the range of 150 ~ 220 ℃; rough temperature range, the temperature can not be accurate for , the presence of excessive heating problems consume energy; and a non-condensing heat-exchange device, a high exhaust gas temperature, the high temperature furnace heat, and therefore relatively high operating costs. Third, the safety and reliability and environmental impact