Burner gas boiler suddenly does not run, why not?

Burner is the most important gas boiler auxiliary equipment, mainly for ignition and combustion of the fuel, a burner not only allows good combustion of fuel, but also to achieve even lower than the oxynitride 80 30 mg matter (NOx) emissions for nitrogen oxides demanding cities (Beijing, Xi'an, Zhengzhou and other places) is very friendly. It can be said burner operating normally or not directly affect the operating results of the gas boiler.

Flue gas condensation in aqueous industrial boilers and industrial boiler flue gas condensing position of the condensation water and the condensed position 1, the industrial steam boiler suppliers flue gas dew point of industrial coagulation process means starts to condense water vapor in the flue gas the temperature, condenses into water vapor when the temperature is lower than the dew point temperature. Without considering the impact of the acid gas, flue gas dew point increases to increase, increasing the concentration of water vapor in the flue gas, increases as the excess air ratio is reduced. Formation of condensation water depends on the temperature distribution of the flow cross-section. For example, when the flue gas through the pipe, the core flow temperature maximum, minimum wall temperature. When the wall temperature is higher than the dew point, no condensate water, when the wall temperature below the dew point temperature of the core flow above the dew point. When the core flow temperature below the dew point, the air flow condensing section. Number of smoke generated condensed water is affected by many factors, such as size, fuel, exhaust gas temperature, the air ratio, the structure of the boiler heat transfer surfaces and the like. 2, boiler condensate condensed gas industry position in the boiler in order to improve the thermal efficiency of the boiler, efficient recovery of the latent heat of the flue gas steam gasification boiler with a condenser and is widely used in industrial heating systems, i.e., by installation absorb latent heat of water vapor in the flue gas. Saving device and a condenser. At design conditions, the flue gas temperature at the outlet of the boiler body above the water vapor dew point temperature, water vapor in the flue gas mainly in the condenser and economizer. Since the high-temperature steam in the boiler, the exhaust gas temperature before the flue gas enters the economizer is generally higher than the dew point, so a small amount of water vapor generated by the boiler condensate, hot water boilers and boiler due to low temperature, return water temperature lower than the annealing furnace smoke gas dew point temperature. Winter start or low load operation, leading to the exhaust gas temperature below the dew point temperature. Thus, prior to entering the economizer, some of the water vapor in the flue gas of the boiler tail heating surface condenses into water. The above analysis, generating the main part of the condensed gas are in industrial boiler economizer heating surface and the boiler, and thus boiler economizer outlet gas industry are usually set in a drain nozzle of the heating surface.

For more than two decades, it has been the focus on clean boilers, the insistence on precision and wisdom, and the pursuit of exquisite craftsmanship that have made today's Fangkuai boilers. Fangkui Boiler will always be based on the boiler industry, and will return customer support and trust with brilliant results and sophisticated technology.

10 ton biomass industrial steam boiler suppliers exported to Nigeria

CBM once again exported a boiler to Nigeria. This boiler is a 10 ton szl series biomass steam boiler that supplies steam to a local paper mill. This company is in contact with us by visiting our official website. Although the customer did not come to our company to visit, but our strong strength, customers all over the world, quality service, efficient products have been recognized by customers. The end customer chooses to purchase our biomass boiler.